Owners Manual

Figure 46. Removing the storage controller card

Next step

1 Install the storage controller card.

Installing the storage controller card

Prerequisite

Follow the safety guidelines listed in Safety instructions.

Steps

1 Connect the SAS cables to the card.

NOTE

: Ensure that you use the labels on the cable to connect the cables to the correct connectors. The cable does not

function properly if reversed.

2 Hold the storage controller card by its edges, and align the connector on the card with the connector on the system board.

3 Lower the card into the system until the card is rmly seated.

4 Route the SAS cable through the channel on the inner side of the chassis.

5 Connect the SAS cables from the storage controller card to the connectors on hard drive backplane.

6 Close the riser retention bracket and slide the bracket to lock the storage controller card.

Installing and removing system components