Owners Manual

Figure 45. Install the NDC riser
Next steps
1 Connect the cables to the NDC riser.
2 Follow the procedure listed in After working inside your system.
Storage controller card
The storage controller card is installed on the expansion card slot on the system board, which provides the integrated storage subsystem
for your system’s internal hard drives. The controller supports SAS and SATA hard drives and also enables you to set up the hard drives in
RAID congurations as supported by the version of the storage controller included with your system.
Removing the storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the Network Daughter Card (NDC) riser.
Steps
1 Slide the riser retention bracket to unlock the storage controller card.
2 Hold the storage controller card by its edges and lift to remove it from the connector on the system board.
3 Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
94
Installing and removing system components