Owners Manual

Steps
1 Slide the riser retention bracket to unlock the NDC riser.
2 Hold the NDC riser by its edges, and pull the NDC riser until the card edge connector disengages from the connector on the system
board.
3 Lift the NDC riser from the system.
Figure 44. Removing the NDC riser
Next step
1 Install the NDC riser.
Installing the NDC riser
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Hold the Network Daughter Card (NDC) riser by its edges and align the connector on the NDC riser and guide pin on the system
board.
2 Insert the NDC riser until the card is fully seated.
3 Close the riser retention bracket and slide the bracket to lock the NDC riser.
Installing and removing system components
93