Owners Manual

Figure 32. Removing the drive from the drive carrier

Next step

If applicable, install the drive into the drive carrier.

Installing a drive into the drive carrier

Prerequisites

CAUTION

: Mixing drive carriers from other generations of XC Series Appliance and XC Core System is not supported.

NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.

Steps

1 Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.

2 Align the screw holes on the drive with the screws holes on the drive carrier.

When aligned correctly, the back of the drive is ush with the back of the drive carrier.

3 Using the Phillips #1 screwdriver, secure the drive to the drive carrier with screws.

Installing and removing system components