Owners Manual
4 Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
5 Connect the cable to the connector (INTRUSION) on the system board.
Figure 27. Installing an intrusion switch
Next steps
1 Lift the sides of the fan tray until the blue release tabs click in place.
2 If applicable, install the expansion card risers.
3 Install the air shroud.
4 Install the fan cage.
5 Follow the procedure listed in After working inside your system.
Drives
Drives are supplied in hot swappable drive carriers that t in the drive slots.
CAUTION
: Before attempting to remove or install a drive while the system is running, see the documentation for the storage
controller card to ensure that the host adapter is congured correctly.
CAUTION: Do not turn o or restart your system while a drive is being formatted. Doing so can cause a drive failure.
When you format a drive, allow enough time for the formatting to complete. Be aware that high-capacity drives can take a long time to
format.
This section contains information about the removal and installation of the hard-drive blank, hot-swappable hard drive, the removal and
installation of the hard drive from the hard-drive carrier.
Installing and removing system components
71