Owners Manual

6 Press the blue release tabs on the fan tray and lower the sides of the tray.
7 Disconnect the cable connected to the intrusion switch connector (INTRUSION) on the system board.
Steps
1 Press the cable management bracket down until the tabs on the bracket disengage from the slots on the side of the system.
2 Lift the cable management bracket out of the system.
3 Press the tab on the intrusion switch cable connector and disconnect the cable connected to the intrusion switch connector
(INTRUSION) on the system board.
4 Remove the cables routed through the cable routing hooks on the right side of the system.
5 Push the intrusion switch out of the intrusion switch slot.
Figure 26. Removing an intrusion switch
Next step
Install an intrusion switch.
Installing an intrusion switch
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Slide the intrusion switch into the intrusion switch slot.
2 Route the cables through the cable routing hooks on the side of the system.
3 Lower the cable management bracket into the system.
70
Installing and removing system components