Owners Manual

Figure 23. Installing the fan cage

Next step

1 Follow the procedure listed in After working inside your system.

Removing the fan tray

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 Remove the air shroud.

4 Remove the fan cage.

5 If installed, remove the expansion card riser.

6 If applicable, lift the PEM by using the PEM handle until the PEM is in an upright position.

7 Release the backplane and fan power cables from the cable clips on the fan tray and disconnect the power cables from the

connectors on the system board.

Steps

1 Press the blue release tabs on the side of the fan tray to unlock the tray.

2 Holding the fan tray lift the tray out of the system.

Installing and removing system components