Owners Manual
Step
To remove the air shroud from a four processor conguration system:
a Remove the expansion card risers. See Removing the expansion card riser.
b Hook the expansion card riser on the side of the system by using the I/O riser handle on the expansion card riser.
CAUTION: To avoid damage to the PCIe cables connected to the NVMe cards installed in the expansion card riser,
ensure that you hook the riser to the system using the I/O riser handle.
c Hold the shroud at both ends and lift it away from the system.
Figure 18. Removing the air shroud — Four processor system
Next step
Install the air shroud.
Installing the air shroud
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Step
To install the air shroud in a four processor conguration system:
a Align the slots on the air shroud with the tabs on the processor expansion module (PEM) handle.
b Lower the air shroud into the system until it is rmly seated.
When rmly seated, the memory socket numbers marked on the air shroud align with the memory sockets on the PEM.
c Press the blue touch point to ensure that the air shroud is seated rmly.
d Unhook the expansion card riser from the side of the system.
e Install the expansion card risers. See Installing the expansion card riser.
62
Installing and removing system components