Owners Manual

Option Description

Drive Type Species the type of drive attached to the SATA port.

Capacity Species the total capacity of the hard drive. This eld is undened for removable media

devices such as optical drives.

Port B Sets the drive type of the selected device. For the Embedded SATA settings in ATA mode, set this eld to Auto to

enable BIOS support. Set it to OFF to turn o BIOS support.

For AHCI or RAID mode, BIOS support is always enabled.

Option Description

Model Species the drive model of the selected device.

Drive Type Species the type of drive attached to the SATA port.

Capacity Species the total capacity of the hard drive. This eld is undened for removable media

devices such as optical drives.

Port C Sets the drive type of the selected device. For the Embedded SATA settings in ATA mode, set this eld to Auto to

enable BIOS support. Set it to OFF to turn o BIOS support.

For AHCI or RAID mode, BIOS support is always enabled.

Option Description

Model Species the drive model of the selected device.

Drive Type Species the type of drive attached to the SATA port.

Capacity Species the total capacity of the hard drive. This eld is undened for removable media

devices such as optical drives.

Port D Sets the drive type of the selected device. For the Embedded SATA settings in ATA mode, set this eld to Auto to

enable BIOS support. Set it to OFF to turn o BIOS support.

For AHCI or RAID mode, BIOS support is always enabled.

Option Description

Model Species the drive model of the selected device.

Drive Type Species the type of drive attached to the SATA port.

Capacity Species the total capacity of the hard drive. This eld is undened for removable media

devices such as optical drives.

NVMe Settings

NOTE

: The XC Series Appliance and XC Core System does not support the NVMe drives with RAID.

NOTE: The XC Series Appliance and XC Core System does not support the NVDIMM-N, RAID, or UEFI settings.

The NVMe settings enable you to set the NVMe drives to either RAID mode or Non-RAID mode.

NOTE

: To congure these drives as RAID drives, you must set the NVMe drives and the Embedded SATA option in the SATA

Settings menu to RAID mode. If not, you must set this eld to Non-RAID mode.

Pre-operating system management applications 39