Owners Manual

Figure 52. Removing the system battery
3 To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4 Press the battery into the connector until it snaps into place.
Figure 53. Installing the system battery
Next steps
1 If applicable, install the PEM.
2 If applicable, install the expansion card risers.
3 If applicable, connect the cables to the expansion card(s).
4 Install the air shroud.
5 Follow the procedure listed in After working inside your system.
6 While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
7 Enter the correct time and date in the System Setup Time and Date elds.
8 Exit the System Setup.
Entering the system Service Tag by using System Setup
You can use System Setup to enter the Service Tag.
1 Turn on the system.
2 Press F2 to enter System Setup.
3 Click Service Tag Settings.
4 Enter the Service Tag.
NOTE
: You can enter the Service Tag only when the Service Tag eld is empty. Ensure that you enter the correct Service
Tag. After the Service Tag is entered, it cannot be updated or changed.
5 Click Ok.
6 Import your new or existing iDRAC Enterprise license.
For more information, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.
104
Installing and removing system components