Service Manual

Figure 47. Removing the bay intrusion switch

Next steps

Replace the bay intrusion switch.

Installing bay intrusion switch

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Follow the procedure listed in Before working inside your system.

3. If installed, remove the front bezel.

4. Open the drive bays.

5. Remove the drive bay 1 bracket.

Steps

1. Align the intrusion switch to the intrusion switch slot in drive bay 1.

2. Using a Phillips #1 screwdriver, replace the screws to secure the intrusion switch.

3. Connect the intrusion cable to the backplane of drive bay 1.

Installing and removing system components