Service Manual

Figure 46. Installing bay 2 backplane brackets

Next steps

1. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.

2. Open the drive bays, install all drives, and then close the drive bays.

3. Install the power supply units.

4. If removed, install the front bezel

5. Follow the procedure listed in After working inside your system.

Bay intrusion switch

Removing bay intrusion switch

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Follow the procedure listed in Before working inside your system.

3. If installed, remove the front bezel.

4. Open the drive bays.

5. Remove the drive bay 1 bracket.

Steps

1. Disconnect the intrusion switch cable connected to the backplane of drive bay 1.

2. Using a Phillips #1 screwdriver, remove the screws securing the intrusion switch to the intrusion switch slot.

3. Disengage the intrusion switch from the intrusion switch slot and remove it from the system.

Installing and removing system components