Service Manual

Figure 24. Removing the HBA 330 from the internal PERC riser

Next steps

Replace the PERC card into the PERC riser

Installing PERC card into the internal PERC riser

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Power off the system and all attached peripherals.

3. Disconnect the system from the electrical outlet, and disconnect the peripherals.

4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.

5. Open the drive bays, remove all drives, and then close the drive bays.

6. Remove the power supply units.

7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at

www.dell.com/xcseriesmanuals.

8. Remove the system cover.

9. Remove the air shroud.

10. Remove the internal PERC riser.

Steps

Align the PERC card to the guiding pins on the internal PERC riser and push the card in.

Installing and removing system components