Service Manual

Figure 19. Installing air shroud

Next steps

1. If removed, install the butterfly riser.

2. Install the system cover.

3. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.

4. Open the drive bays, install all drives, and then close the drive bays.

5. Install the power supply units.

6. Follow the procedure listed in After working inside your system.

Internal PERC riser

Removing the internal PERC riser

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Power off the system and all attached peripherals.

3. Disconnect the system from the electrical outlet, and disconnect the peripherals.

4. Open the drive bays, remove all drives, and then close the drive bays.

5. Remove the power supply units.

6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at

www.dell.com/xcseriesmanuals .

7. Remove the system cover.

8. Remove the air shroud.

9. Open the cable guiding latch for easy access.

Steps

1. Lower the plunger and holding the blue touch points, lift the internal PERC riser out of the system.

Installing and removing system components