Service Manual

10. Remove the cable chain assembly.
Steps
1. Align the left control panel assembly with the control panel slot on the chassis and using Phillips #1 screwdriver, replace the screws to
secure the left control panel assembly to the chassis.
2. Route the left control panel cable through the cable channel of the system.
Figure 120. Installing the left control panel
3. Connect the control panel cable to the system board connector.
Next steps
1. Install the cable chain assembly.
2. Close the drive bays.
3. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
4. Install the power supply units.
5. Open the drive bays, install all drives, and then close the drive bays.
6. If removed, install the front bezel.
7. Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions
2. Power off the system and all attached peripherals.
3. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4. Open the drive bays, remove all drives, and then close the drive bays.
5. Remove the power supply units.
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals.
7. If installed, remove the front bezel
8. Remove the system cover.
9. Remove the air shroud.
130
Installing and removing system components