Service Manual

Figure 96. Installing the MicroSD card
Next steps
1. Install the IDSDM or vFlash module
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
5. Open the drive bays, install all drives, and then close the drive bays.
6. Install the power supply units.
7. Follow the procedure listed in After working inside your system.
LOM riser card
Removing the LOM riser card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove all drives, and then close the drive bays.
5. Remove the power supply units.
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/xcseriesmanuals .
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the risers.
Steps
1. Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2. Release the two blue plastic clips holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
Installing and removing system components
107