Service Manual

Figure 90. Installing butterfly riser

Next steps

2. Install the air shroud.

3. Install the system cover.

4. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.

5. Open the drive bays, install all drives, and then close the drive bays.

6. Install the power supply units.

7. Install any device drivers required for the card as described in the documentation for the card.

8. Follow the procedure listed in After working inside your system.

M.2 SSD module

Removing the M.2 SSD module

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Power off the system and all attached peripherals.

3. Disconnect the system from the electrical outlet, and disconnect the peripherals.

4. Open the drive bays, remove all drives, and then close the drive bays.

5. Remove the power supply units.

6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at

www.dell.com/xcseriesmanuals.

7. Remove the system cover.

8. Remove the air shroud.

9. Remove the BOSS card.

10.

NOTE:

The procedure to remove the BOSS card is similar to the remove an expansion card.

Installing and removing system components 101