Owners Manual

NOTE: Ensure that the PHM is held parallel to the system board to prevent damaging the components.

2 Push the blue retention clips inward to allow the heat sink to drop into place.

3 Using the #Torx T30 screwdriver, tighten one screw at a time.

NOTE: Ensure that the screw is tightened completely before moving onto the next screw.

NOTE: The processor and heat sink module retention screws should not be tightened to more than 0.13 kgf-m (1.35 N.m or

12 in-lbf).

Figure 46. Installing the processor and heat sink module (2U)

Figure 47. Installing a processor and heat sink module (1U)

Next steps

1 If removed, install the expansion card risers.

2 If disconnected, connect the cables to the expansion card(s).

3 If applicable, install the air shroud.

Installing and removing system components