Owners Manual
NOTE: Universal slots are slots that support SAS, SATA hard drives/SSDs, or NVMe drives in the same slot.
Ports and connectors specications
USB ports
The XC740xd Series Hyper-converged Appliances support:
• Two USB 2.0-compliant ports on the front panel
• One internal USB 3.0-compliant port
• One micro USB 2.0-compliant port in the front panel for iDRAC Direct
• Two USB 3.0-compliant ports on the back panel
NIC ports
The XC740xd Series Hyper-converged Appliances support up to four Network Interface Controller (NIC) ports that are integrated on the
network daughter card (NDC), and are available in the following congurations:
• Four RJ-45 ports that support 10, 100 and 1000 Mbps
• Four RJ-45 ports that support 100 M, 1 G and 10 Gbps
• Four RJ-45 ports, where two ports support maximum of 10 G and the other two ports maximum of 1 G
• Two RJ-45 ports that support up to 1 Gbps and 2 SFP+ ports that support up to 10 Gbps
• Four SFP+ ports that support up to 10 Gbps
• Two SFP28 ports that support up to 25 Gbps
NOTE
: You can install up to six PCIe add-on NIC cards.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The XC740xd Series Hyper-converged
Appliances support two 15-pin VGA ports on the front and back panels.
Serial connector
The XC740xd Series Hyper-converged Appliances support one serial connector on the back panel, which is a 9-pin connector, Data
Terminal Equipment (DTE), 16550-compliant.
IDSDM/vFlash card
The IDSDM/vFlash card combines the IDSDM and/or vFlash features into a single module
26
Technical specications