Owners Manual

Steps
1 Pull the cable latch and disconnect the control panel cable from the system board connector.
2 Using Phillips #1 screwdriver, remove the screws that secure the cable cover, which secure the control panel and cable tube to the
system.
3 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Figure 75. Removing left control panel
Next step
Install the left control panel.
Installing the left control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the control panel cable to the system board connector and secure it using cable latch.
4 Using Phillips #1 screwdriver, install the screws that secure the cable panel and cable tube to the system.
Installing and removing system components
125