Owners Manual
Figure 60. Installing IDSDM card
Next steps
1 Install the micro SD cards.
NOTE
: Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.
2 If applicable, install the rear hard drive cage.
3 If applicable, install the full height PCIe card.
4 Follow the procedure listed in After working inside your system.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the exibility of selecting dierent network
connectivity options.
Removing the network daughter card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the expansion card riser 2.
Steps
1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2 Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3 Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Installing and removing system components
109