Owners Manual

Figure 58. Installing an expansion card riser 3
Next steps
1 If removed, install expansion cards into the riser.
2 Install the air shroud.
NOTE
: If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
3 Follow the procedure listed in After working inside your system.
4 Install any device drivers required for the card as described in the documentation for the card.
IDSDM/vFlash card
The IDSDM/vFlash card combines the IDSDM and/or vFlash features into a single module
Removing a micro SD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
Steps
1 Locate the SD card slot on the IDSDM module, and press the card to partially release it from the slot.
2 Hold the SD card and remove it from the slot.
NOTE
: Temporarily label each SD card with its corresponding slot number after removal.
Next step
Install a micro SD cards.
106
Installing and removing system components