Owners Manual

Figure 57. Removing the expansion riser 3
Next step
Install the expansion card riser 3.
Installing an expansion card riser 3
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the following:
a Tab on the riser with the slot on the system and guide rails on the riser with the standos on the side of the system
b Lower the riser into the system until the riser connector engages with the connector on the system board.
c The riser card edge engages with the riser guide on the system.
2 Tighten the screw to secure the riser to the system by using Phillips #2 screwdriver.
Installing and removing system components
105