Owners Manual

Figure 56. Installing an expansion card riser 2A
Next steps
1 Install the air shroud.
2 If removed, install expansion cards into the riser.
3 If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
4 Follow the procedure listed in After working inside your system.
5 Install any device drivers required for the card as described in the documentation for the card.
Removing an expansion card riser 3
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
NOTE
: If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4 If installed, expansion cards from the riser.
5 Disconnect any cables connected to the riser card.
Step
To remove expansion card riser 3:
a loosen the screws that secure the riser to the system by using Phillips #2 screwdriver.
b Press the release tab, holding the riser by its edges, and then lift the riser from the riser connector on the system board.
104
Installing and removing system components