Owners Manual

Figure 55. Removing the expansion riser 2A
Next step
Install the expansion card riser 2.
Installing an expansion card riser 2
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Step
To install expansion card riser 2A:
a Align the screw and tab on the riser with the screw hole and slot on the system.
b Lower the riser into the system until the riser connector engages with the connector on the system board.
c Tighten the screws by using Phillips #2 screwdriver to secure the riser to the system.
Installing and removing system components
103