Owners Manual

Removing an expansion card riser 1
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the expansion cards from the riser.
4 Disconnect any cables connected to the riser.
Step
Press the release latches, and lift the riser from the riser connector on the system board.
Figure 53. Removing an expansion card riser 1
Next step
Install the expansion card riser 1.
Installing an expansion card riser 1
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the guide rails on the riser with the standos on the side of the system.
2 Lower the riser into the system until the riser connector engages with the connector on the system board.
Installing and removing system components
101