Service Manual

VGA module
Remove the VGA module
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before you work inside your system.
● Remove the front bezel.
● Remove the drive backplane cover.
● Remove the air shroud.
● Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the Jumpers and
connectors section.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
Figure 80. Removing the VGA module
Next steps
Install the VGA module.
Install the VGA module
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before you work inside your system.
● Remove the front bezel.
● Remove the drive backplane cover.
● Remove the air shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
108 Installing and removing system components