Owners Manual

Figure 60. Removing the hard drive backplane
Figure 61. 4 X 3.5 hard drive backplane
1
release tab (2) 2 SAS cable connector
3 power cable connector 4 backplane signal cable connectorNext
Next step
Install the hard drive backplane.
Installing the hard drive backplane
Prerequisites
Follow the safety guidelines listed in Safety instructions.
CAUTION
: To prevent damage to the control panel ex cable, do not bend the control panel ex cable after it is inserted into the
connector.
NOTE: The procedure to install the backplane is identical for all backplane congurations.
Steps
1 Use the hooks on the system as guides to align the slots on the backplane with the guides on the system.
2 Lower the hard drive backplane until the release tabs snap into place.
Installing and removing system components
107