Owners Manual

Table 45. Settings for XC640-10
Name State Slot Number Size Security Status Bus Protocol Media Type
PCle SSD in Slot
6 in Bay 1
Ready 6 1490.42 GB Not Applicable PCle SSD
PCle SSD in Slot
7 in Bay 1
Ready 7 1490.42 GB Not Applicable PCle SSD
PCle SSD in Slot
8 in Bay 1
Ready 8 1490.42 GB Not Applicable PCle SSD
PCle SSD in Slot
9 in Bay 1
Ready 9 1490.42 GB Not Applicable PCle SSD
Removing the hard drive backplane
Prerequisites
CAUTION: To prevent damage to the drives and backplane, remove the hard drives from the system before removing the
backplane.
CAUTION: Note the number of each hard drive and temporarily label them before you remove the hard drive so that you can
replace them in the same location.
NOTE: The procedure to remove the backplane is similar for all backplane congurations.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the backplane cover.
5 Remove all hard drives from the front bay.
6 Disconnect all the cables from the backplane.
Step
Press the release tabs and lift the backplane to disengage the backplane from the hooks on the system.
NOTE
: If your backplane has an expander board, the loosen the screws on the expander board before you remove the
backplane.
106 Installing and removing system components