Owners Manual

Figure 36. Installing the mezzanine card bridge board

Next steps

1 Install the mezzanine card.

2 Install the expansion card riser assembly.

3 Install the sled into the enclosure.

4 Follow the procedure listed in After working inside your system.

Removing the OCP card

Prerequisites

NOTE

: The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 Remove the sled from the enclosure.

4 Remove the mezzanine card.

Steps

1 Push the blue retention clips away on one side and release the Open Compute Project (OCP) card.

Repeat step 1 to release the card from the clips on the other side.

2 Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.

Installing and removing system components