Owners Manual

Figure 30. Installing the M.2 SATA x16 riser

Next steps

1 Install the sled into the enclosure.

2 Follow the procedure listed in After working inside your system.

Removing the M.2 SATA card

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 Remove the sled from the enclosure.

4 If applicable, remove the expansion card riser assembly.

5 Remove the M.2 x16 riser.

Steps

1 Using the Phillips #1 screwdriver, unscrew the screw that secures the M.2 card to the board.

2 Pull the card out of the connector and lift the card away.

Installing and removing system components