Owners Manual

Figure 29. Removing the M.2 SATA x16 riser

Next step

Install the M.2 SATA x16 riser.

Installing the M.2 SATA x16 riser

Prerequisite

1 Follow the safety guidelines listed in Safety instructions.

Steps

1 Connect the data cable to the riser.

2 Insert the keyed end of the M.2 SATA riser into the lock on the system board.

3 Align and insert the edge connector into the connector on the system board.

4 Using the Phillips #2 screwdriver, tighten the screw to secure the riser to the sled.

Installing and removing system components