Owners Manual
Figure 26. Installing an expansion card
Next steps
1 Install the expansion card riser assembly.
2 Install the sled into the enclosure.
3 Follow the procedure listed in After working inside your system.
Removing the riser card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the sled from the enclosure.
4 Remove the expansion card riser assembly.
5 If installed, remove the expansion card.
Steps
1 Using the Phillips #2 screwdriver, remove the screws that secure the riser card to the expansion card bracket.
2 Lift the riser card away from the expansion card bracket.
72
Installing and removing system components