Owners Manual

Figure 22. Installing the expansion card riser assembly
Next steps
1 Install the sled into the enclosure.
2 Follow the procedure listed in After working inside your system.
Removing an expansion card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the sled from the enclosure.
4 Remove the expansion card riser assembly.
Steps
1 Remove the screw that secures the expansion card to the assembly.
2 Hold the expansion card by its edges, and carefully remove it from the riser card.
NOTE
: You must install an expansion card ller bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airow inside the system.
68 Installing and removing system components