Owners Manual

CAUTION: Handle each memory module only by the edges, ensuring not to touch the middle of the memory module or
metallic contacts.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do not bend or ex
the memory module. You must insert both ends of the memory module simultaneously.
2 Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3 Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module
in the socket.
CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module
evenly.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in only
one orientation.
4 Press the memory module with your thumbs until the socket levers rmly click into place.
Figure 18. Installing a memory module
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
3 To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reect the updated capacity of the installed
memory.
4 If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is rmly
seated in the memory module socket.
5 Run the system memory test in system diagnostics.
Support bracket
Removing the support bracket
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
Installing and removing system components
63