Owners Manual

Figure 13. Installing a sled blank

Next step

Follow the procedure listed in After working inside your system.

NOTE

: To add the Service Tag of the system board to match the Service Tag of the physical node, contact Dell EMC Technical

Support.

Air shroud

The air shroud aerodynamically directs the airow across the sled. The airow passes through all the critical parts of the sled, where the

fans push the air across the entire surface area of the heat sink. There is a vacuum created by air pulled across the hard drives, thus

allowing increased cooling.

Removing the air shroud

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 Remove the sled from the enclosure.

Steps

1 Press the clip on the air shroud to release the shroud from the sled.

2 Remove the shroud by rotating the shroud and releasing the hinge from the slot on the system.

Installing and removing system components