Users Guide

On some cases the Virtual IP address is captured by DSU in place of OS IP, in such scenarios the IP address displayed will not be correct.

On the remote systems running SUSE Linux 15 servers, the remote system is unable get connected after a restart.

This is due to the rewall which could be enabled after a restart.

Host System displays an error message as "unknown option provided in DSU" when the option UseLatestDSU=FALSE mentioned

in cong le.

Set the value of attribute value as TRUE. If the lesser version of DSU installed on target system all the functionality or the options for

remote feature is not enabled hence following message can be thrown in the case.

While using --push-remote-updates option on systems running SUSE Linux operating systems , updates failure message is

observed.

Reason for failure message is the updates fails to download on the host system.

In such scenarios try using option --source-type=REPOSITORY along with --source-location=<repo-location>.

Libgpme library not found, on Ubuntu operating systems to run any DSU command.

Error occurs when libgpgme library not found on the host system.

Solution: libgpgme library is one of the dependency for DSU. Please install it on your host system

Unable to connect error occurs while running the DSU with option -use-idrac-passthrough.

In case of USB-NIC already enabled status the interface settings then there are no actions carried out by DSU hence failure is observed.

Solution: Change the state of USB-NIC in passthrough conguration to disable on iDRAC system and retry.

[iDRAC Settings->Connectivity->OS to iDRAC Pass-through->State]

For more information see, Integrated Dell Remote Access Controller User's Guide at www.dell.com/iDRACmanuals.

IDSDM rmware update fails for iDRAC remote system.

This DUP is not supported via iDRAC.

Recommendation: Run the DUP directly on the operating system.

DSU fails to connect to the system when the iDRAC is congured on a non-default HTTPS port.

Single remote iDRAC with non-default port fails to get the inventory, preview or update command information.

Recommendation: It supports only by providing the non-default port details in a Cong le.

Sample cong le:

<DSUConfig xmlns="DSUConfiguration>"

</AuthenticationSequence>

</System>>

</RemoteSystem>

</DSUConfig>

Frequently asked questions