Owners Manual

Figure 49. Installing the network daughter card

Next steps

1. Install the expansion card riser 2, depending on the configuration of your system.

2. Follow the procedures in After working inside your system.

Integrated storage controller card

Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage

controller card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives

and also enables you to set up the drives in RAID configurations as supported by the version of the storage controller.

Removing the integrated storage controller card

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedures in Before working inside your system.

3. Remove the air shroud.

Steps

1. Use the Phillips #2 screwdriver to loosen the screws that secure the integrated storage controller cable to the connector on

the system board.

2. Lift the integrated storage controller cable to disconnect it from the connector on the system board.

Installing and removing system components