Owners Manual

Figure 81. Installing the cable cover
Next steps
1. Install the air shroud.
2. If applicable, install the cooling fan # 1.
3. Follow the procedures in After working inside your system.
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1. Lift the cable latch, and disconnect the control panel cable from the connector on the system board.
2. Use the Phillips #1 screwdriver to remove the screws that secure the cable cover to the system.
Figure 82. Removing the cable cover
3. Use the Phillips #1 screwdriver to remove the screw that secures the control panel to the system.
Installing and removing system components
115