Owners Manual

8. Select the TPM Advanced Settings option.
9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10. On the System Security Settings screen, from the Intel TXT option, select On.
11. Save the settings.
12. Restart your system.
Control panel
The control panel allows you to manually control the inputs to the system.
Your system contains:
● Left control panel: Contains status LEDs, system ID button, and iDRAC Quick Sync 2.
● Right control panel: Contains power button, USB 2.0 port, micro USB for iDRAC Direct, and status LED for iDRAC Direct.
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the air shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
4. For ease of removal of the left control panel, remove the cooling fan #1 to access the cable latch.
Steps
1. Pull the cable latch, and then disconnect the control panel cable from the system board connector.
2. Use the Phillips #1 screwdriver to remove the screws that secure the cable cover.
Figure 78. Removing the cable cover
3. Use the Phillips #1 screwdriver to remove the screws that connect the control panel to the system.
Installing and removing system components
113