Owners Manual

Figure 68. Installing the USB module
Next steps
1. Install the air shroud.
2. Install the backplane cover.
3. Follow the procedures in After working inside your system.
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To
boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the
boot sequence in System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port and can be used as a boot device, security key or
mass storage device.
The internal USB port is on the system board.
NOTE: To locate the internal USB port on the system board, see System board jumpers and connectors.
For configurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system
board. In this scenario, the default internal USB port is available under the backplane cover. The position of the default internal
USB port may vary depending on the configuration of your system.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the system, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
Steps
1. Locate the USB port or USB memory key on the system board.
102
Installing and removing system components