Owners Manual

Figure 65. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 66. Installing the system battery
Next steps
1. Install the expansion card riser 1A.
2. If applicable, connect the cables to the expansion card(s) in the expansion card riser 1A.
3. Follow the procedures in After working inside your system.
4. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5. Enter the correct time and date in the System Setup Time and Date fields.
6. Exit the System Setup.
USB module
An additional USB port can be added to the front of the system. Depending on the configuration of your system, you can add
either a USB 3.0 or USB 2.0 module. The USB module cable connects to the internal USB port on the system board.
Removing the USB module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the backplane cover.
4. Remove the air shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
NOTE: The procedure to remove the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Disconnect the USB cable from the USB connector on the system board. For more information, see the System board
jumpers and connectors on page 51 section.
100
Installing and removing system components