Owners Manual

Figure 47. Installing an expansion card into the expansion riser 2A
Next steps
1. After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the
expansion card.
2. Follow the procedures in After working inside your system.
3. Install any device drivers required for the card as described in the documentation for the card.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the flexibility of selecting different
network connectivity options.
Removing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser 2, depending on the configuration of your system.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system
board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Installing and removing system components
85