Owners Manual
Table Of Contents
- PowerVault NX3340 Network Attached Storage System Installation and Service Manual
- Contents
- NX3340 system product overview
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System Information
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Choosing system boot mode
- Changing boot order
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Diagnostics and indicators
- Jumpers and connectors
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System cover
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- System memory
- Processors and heat sinks
- Expansion cards and expansion card risers
- Network daughter card
- Integrated storage controller card
- Hard drives
- Drive backplane
- System battery
- USB module
- Optional internal USB memory key
- Optical drive—optional
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- Getting help
Front view of the system
This section describes the features available on the front of the system.
Figure 2. Front view of 8 x 2.5 inch drive system
Item Ports, panels, and
slots
Icon Description
1 Left control panel N/A
Contains the system health and system ID, status LED, and the iDRAC Quick Sync 2
(wireless) indicator.
● Status LED: Enables you to identify any failed hardware components. There are
up to five status LEDs and an overall system health LED (Chassis health and
system ID) bar. For more information, see Status LED indicators.
● Quick Sync 2 (wireless): Indicates a Quick Sync enabled system. This feature
allows management of the system by using mobile devices. This feature
aggregates hardware or firmware inventory and various system level diagnostic
and error information that can be used in troubleshooting the system. For more
information, see the Integrated Dell Remote Access Controller User’s Guide at
Dell.com/idracmanuals.
2 Optical drive N/A One optional slim SATA DVD-ROM drive or DVD+/-RW drive.
NOTE: DVD devices are data only.
3 USB port (optional)
The USB port is USB 3.0 compliant.
4 VGA port Enables you to connect a display device to the system. For more information, see
Technical specifications on page 14.
5 Right control panel N/A Contains the power button, USB port, iDRAC Direct microUSB port, and the iDRAC
Direct status LED.
6 Drive slots N/A Enable you to install drives that are supported on your system. For more information
about the supported drives, see Technical specifications on page 14.
8 NX3340 system product overview