Owners Manual

Table 13. Riser configurations:1A (continued)
Card type Slot priority Form factor
Non-RAID (Dell design) 1 Low Profile
Infiniband HCA EDR (Mellanox) 1, 2 Low Profile
100G NICs (Mellanox) 1, 2 Low Profile
Omni-Path HFI (Intel) 1, 2 Low Profile
Infiniband HCA FDR (Mellanox) 1, 2 Low Profile
40G NICs (Intel) 1, 2 Low Profile
40G NICs (Mellanox) 1, 2 Low Profile
FC32 HBA (QLogic) 1, 2 Low Profile
FC32 HBA (Emulex) 1, 2 Low Profile
25G NICs (Broadcom) 1, 2 Low Profile
25G NICs (Mellanox) 1, 2 Low Profile
25G NICs (QLogic) 1, 2 Low Profile
FC16 HBA (QLogic) 1, 2 Low Profile
FC16 HBA (Emulex) 1, 2 Low Profile
10Gb NICs (Broadcom) 1, 2 Low Profile
10Gb NICs (Intel) 1, 2 Low Profile
10Gb NICs (Mellanox) 1, 2 Low Profile
10Gb NICs (QLogic) 1, 2 Low Profile
10Gb NICs (Solarflare) 1, 2 Low Profile
FC8 HBA (Emulex) 1 Low Profile
FC8 HBA (QLogic) 1, 2 Low Profile
1Gb NICs (Broadcom) 1, 2 Low Profile
1Gb NICs (Intel) 1, 2 Low Profile
External RAID (Dell design) 1, 2 Low Profile
Integrated RAID (Dell design) Integrated Slot NONE
rNDC (Broadcom) Integrated Slot NONE
rNDC (Intel) Integrated Slot NONE
rNDC (Mellanox) Integrated Slot NONE
rNDC (QLogic) Integrated Slot NONE
Removing an expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
4. Disconnect any cables connected to the expansion card.
Installing and removing system components
79