Owners Manual

For information about the cable management arm, see the system’s rack documentation at Dell.com/storagemanuals.
Steps
Press the orange release latch and slide the PSU out of the system by using the PSU handle.
Figure 73. Removing a power supply unit
Next steps
Install the PSU or the PSU blank.
Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum
output power.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
Steps
Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
Installing and removing system components
105