Owners Manual

Figure 63. Installing expansion card into expansion card riser 3

Next steps

1. If applicable, connect the cables to the expansion card.

2. If applicable, install the air shroud.

3. Follow the procedures in After working inside your system.

4. Install any device drivers required for the card as described in the documentation for the card.

Removing the riser 2 blank

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedures in Before working inside your system.

3. Remove the air shroud.

Steps

1. Using Phillips #2 screwdriver, loosen the screws (3) that secure the blank to the system.

2. Press the release tab, and holding the blank by its edges, lift the blank away from the system.

Installing and removing system components