Owners Manual

Steps

Press the release button, and slide the drive blank out of the drive slot.

Figure 32. Removing a drive blank

Next steps

1. Follow the procedures in After working inside your system.

2. Install a drive or a drive blank.

Installing a drive blank

Prerequisites

Follow the safety guidelines listed in Safety instructions.

CAUTION: Mixing drive blanks from previous generations of NAS systems is not supported.

Steps

Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.

Figure 33. Installing a drive blank

Next steps

If removed, install the front bezel.

Removing a drive carrier

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedures in Before working inside your system.

Installing and removing system components