Owners Manual

Figure 24. Removing the mid drive tray

NOTE: The images shown here are for representation only and the actual configuration of your system may vary.

Next steps

Install the mid drive tray.

Installing the mid drive tray

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

NOTE: Systems that support the internal drive tray support low-profile heat sinks and do not support an air shroud.

Steps

1. Lift the drive tray handles to 90 degrees upward.

2. Hold the drive tray handles, and align the slots on the drive tray with the guide pins on the system.

3. Lower the drive tray into the system.

4. Lower the drive tray handles to lock the drive tray in place.

Installing and removing system components