Owners Manual

Steps

1. Align the tabs on the air shroud with the slots on the system.

2. Lower the air shroud into the system until it is firmly seated.

When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.

Figure 17. Installing the air shroud

NOTE: The images shown here are for representation only and the actual configuration of your system may vary.

Next steps

1. If removed, install the full length PCIe cards.

2. Follow the procedures in After working inside your system.

Cooling fan assembly

The cooling fan assembly ensures that the key components of the system such as the processors, drives, and memory get

adequate air circulation to keep them cool. A failure in the NAS system’s cooling system can result in the system overheating

and may lead to damage.

This section contains information about the removal and installation of the cooling fan assembly.

Removing the cooling fan assembly

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedures in Before working inside your system.

Steps

1. Lift the release levers to unlock the cooling fan assembly from the system.

2. Hold the release levers, and lift the cooling fan assembly away from the system.

Installing and removing system components